Four points that should be paid attention to in the design of stainless steel flanges
What should be paid attention to in the design of stainless steel flanges? Friends, do you know? The following is introduced by the editor, I hope it can be helpful to you.
1. Design and manufacture of tooling
The stainless steel flange is welded by 2 clamping bottom plates, 2 flange support plates, 2 vertical plates and 4 reinforcement plates. In order to ensure the rigidity of the tool, the welding of the connecting plate should be through groove welding, and the welding angle should be 20-30mm. Drill corresponding bolt holes on the flange plate to ensure accurate connection between the flange and the bolts used in the flange plate, there is a gap between the back of the flange at the small end and the support plate, so that the flange is loaded into the mold, and A tool made of a thicker steel plate with an approximate groove structure to meet cutting rigidity requirements.
2. Tooling performance requirements
The two flange faces of the stainless steel flange are perpendicular to each other, while the workbench of the vertical lathe rotates horizontally, so the main function of the tool is to use the bolt holes on the big end flange to connect the tool with the flange. When the tool is clamped on the workbench, the machined flange plane should be concentric and parallel to the workbench of the vertical lathe. At the same time, the tool must have sufficient rigidity, otherwise it will seriously affect the processing quality of the flange sealing ring groove, so the height of the tool should be reduced as much as possible under the condition of meeting the use, so as to improve the rigidity and facilitate operation. In order to reduce the number of tools, the tool should be able to Change the clamping position and ensure that the flanges at both ends of the elbow can be processed on one tool. After fixing the tool and the stainless steel flange, the turning radius should not exceed the working radius of the vertical lathe, and it can be easily clamped, adjusted, and fed and cut.
3. Tooling stiffness verification
When turning the stress model of the cantilever beam with groove structure, the deflection and rotation angle of the cantilever beam with groove structure should be checked during bending and torsion. Through the above checks, the maximum deflection is 7.27×Lo-7m and the maximum rotation angle is 8.969×10 -5 are small deformation, rigidity fully meet the cutting force requirements. The maximum turning diameter of the tool and the flange is 2.42m≤3.50m, so the tool is theoretically feasible.
4. Turning
When processing stainless steel flanges, the chassis is adjusted downwards, clamped on the vertical workbench, and the elbow flange is installed manually, and the large end flange is fixed with bolts and support plates to ensure that the flange surface is in line with the vertical table before cutting The working table is parallel and concentric. When processing the small-end flange, clamp the tool base plate on the vertical workbench, and after fastening the small-end flange and the back of the small support plate, the verticality of the flange should be ensured.
The structure of the stainless steel flange tool is simple and reasonable, good rigidity, easy to manufacture, easy to find and adjust and process, and the three sets of elbow flanges processed on the vertical car are all qualified. A new way of machining similar parts on vertical lathes.
