enLanguage

Knowledge

Why should high-pressure butt welding flanges, loopers, threads, lap joints, and blind flanges be galvanized

Galvanizing the flange can improve its corrosion resistance and increase its service life. Galvanizing is to coat the surface of steel products with a layer of zinc, which can form a strong coating and keep the flange surface away from air and moisture, thereby reducing the possibility of flanges being oxidized and corroded. In addition, galvanizing can improve the mechanical strength and welding performance of the flange, and it can also make it more wear-resistant and prevent scratches and damage. Therefore, galvanizing can be an effective protective measure for flanges that are often exposed to water and are subject to severe environmental impacts such as corrosion.

 

The galvanizing of the flange can be carried out by the following steps:

1. Clean the surface: Use detergent and solvent to clean the flange surface to remove surface oil, grease and dirt.

2. Pickling treatment: Soak the flange in the pickling solution to form a layer of ferrite on the surface, which is convenient for the next step.

3. Soak in the galvanizing solution: Put the flange into the galvanizing tank and soak it, and then the surface of the flange is coated with a layer of zinc.

4. Cleaning and oiling: Take the flange out of the galvanizing tank, clean the residue on the surface, and then apply a layer of protective oil.

 

Precautions:

1. Protective gloves, masks and protective glasses must be worn during operation.

2. The chemicals in the pickling and galvanizing tanks should be replaced regularly to ensure the effect.

3. The surface of the flange after galvanizing has a certain anti-corrosion ability, but it needs proper maintenance and maintenance.

You Might Also Like

Send Inquiry