Sealing principle and precautions of flat welding flange
The two sealing surfaces of the bolt press the flange gasket against each other and form a seal, but this also leads to the destruction of the seal. In order to keep the seal, it is necessary to maintain a huge bolt force, for this reason, the bolt will be made bigger. And larger bolts will match larger nuts, which means that bolts with larger diameters are required to create conditions for tightening the nuts. However, the larger the diameter of the bolt, the applicable flange will become curved, and the solution is to increase the wall thickness of the flange part. The whole installation would require a great deal of size and weight, which is a particular problem in the offshore environment, where weight is always the main concern that one has to pay attention to. Moreover, fundamentally speaking, the flat welding flange is an ineffective seal, which requires 50% of the bolt load to squeeze the gasket, while only 50% of the load is used to maintain the pressure. Flat welding flanges are often used in situations where the medium temperature and pressure are not high and the medium is highly corrosive. When the medium is highly corrosive. Flange fittings refer to fittings with flanges (flanges or lands). It can be made by casting, and the flat welding flange is mainly a part that connects the pipe to the pipe. According to the structure type. It can also be constructed by screwing or welding. Flange connection refers to a pair of flanges, a gasket and a number of bolts and nuts.
Matters needing attention for flat welding flanges:
1. The steel plate for the production of flat welding flanges should be ultrasonically inspected, without delamination defects, to ensure good quality and performance problems, and to produce and inspect according to certain quality requirements to ensure that the steel plates produced and used have no quality problems;
2. It should be cut into strips along the rolling direction of the steel, bent and butt-welded into a circular ring, and the surface of the steel forms a circular cylinder. In the production of flat welding flanges, steel plates shall not be directly machined into neck flanges, and certain processes shall be used for production and processing.
When flat welding flange welding adopts single-sided continuous welding, the welding shrinkage in the circumferential direction is very large when the circumferential heated part of the flange welding zone is cooled by the weld seam, which further aggravates the expansion of deformation, and the flange forms an irregular ellipse in the circumferential direction Phenomenon, partly concave, partly convex. At the same time, due to the welding shrinkage force, the inner circumference of the flange becomes smaller, and because the outer side of the flange is at a lower temperature, the influence of welding heat input is small, the rigidity is better, and there is basically no shrinkage; thus the flange section is twisted, forming a method The phenomenon that the blue surface is significantly turned over, and at the same time, the central axis of the bolt hole is no longer parallel to the axis of the cylinder. Facts have proved that the force of this overturning is very large, and after the welding of the groove on the upper section of the flange and the cylinder is completed, the deformation cannot be improved in any way.
