What are the technical requirements for flat welding butt welding flanges?
The butt welding flange is not easy to deform, has good sealing, and is widely used. It has corresponding rigidity and elasticity requirements and reasonable butt welding thinning transition. The distance between the welding port and the joint surface is large, and the joint surface is free from welding temperature deformation. It adopts a relatively complicated The trumpet-shaped structure is suitable for pipelines with large fluctuations in pressure or temperature or high-temperature, high-pressure and low-temperature pipelines. It is generally used for the connection of pipelines and valves with a PN greater than 2.5MPa; it is also used to transport expensive, flammable and explosive materials. medium pipeline.
1. The level and technical requirements of the butt welding flange shall meet the corresponding requirements of J B4726-4728. the
1. Carbon steel and austenitic stainless steel forgings with a nominal pressure PN of 0.25MP-1.0MPa are allowed to use Class I forgings. the
2. In addition to the following provisions, forgings with a nominal pressure PN of 1.6MPa-6.3MPa shall meet the requirements for forgings of Class II or above. the
3. Those who meet one of the following conditions shall meet the requirements of III and forgings: (1) forgings for flanges with nominal pressure PN≥10.0MPa; (2) chrome-molybdenum steel forgings with nominal pressure PN>4.0MPa; Ferritic steel forgings with pressure PN>1.6MPa and working temperature ≤-20 degrees Celsius.
2. Butt welding flanges are generally made by forging or forging process. When steel plate or section steel is used, the following requirements must be met:
1. The welded flange should be ultrasonically inspected and free from delamination defects;
2. It should be cut into strips along the rolling direction of the steel, bent and butt welded into a ring, and the surface of the steel forms a cylindrical surface of the ring. Steel plates shall not be directly machined into welded neck flanges;
3. The butt weld of the circular ring shall adopt the full penetration weld;
4. The butt weld of the circular ring shall be subjected to post-weld heat treatment and subjected to 100-ray or ultrasonic flaw detection, and the radiographic flaw detection meets the requirements of Class II of JB4730, and the ultrasonic flaw detection meets the requirements of Class I of JB4730.
3. The outer slope of the neck of the butt welding flange should not be greater than 7o. The technical parameters of the butt welding flange are strictly controlled during production and welding to ensure that it can fully play its role and value in production and use.
