Forging method of flat welding carbon steel flange
According to the movement mode of the forging die, the forging of flat welded carbon steel flanges can be divided into swing forging, swing forging, roll forging, cross wedge rolling, rolling and cross rolling. Oscillating rolling, oscillating rolling and ring forgings can also be precision forged. In order to improve the utilization rate of data, roll forging and cross rolling can be used as the preprocessing of slender data. Spin casting, like free forging, is also partially formed. This has the advantage that it can be formed when the casting forces are relatively small compared to the casting dimensions. Carbon steel flanges can be completed by one or more processes. Because there is no flash, the force cutting area is large during forging, and the load requirement is also greatly reduced. This kind of casting method, including free forging, flat welding flange processing data extends from the mold surface close to the free surface, therefore, it is difficult to guarantee the accuracy, so the movement direction of the forging mold and the order of the spinning blacksmith are controlled by the computer, which can be used for casting Products with low force, random shape and high precision. For example, the production of various large steam turbine blade forging. The casting of flat welding flanges can be divided into free forging, upsetting forging, kneading, die forging, closed die forging and closed upsetting. Generally speaking, castings in the recrystallization temperature zone are called hot forging, and castings that are not heated at room temperature are called cold forging. When casting flat welding flanges at low temperature, the size of the forgings is very small. When casting at 700°C, there is almost no scale formation on the surface and no decarburization.
Precautions when welding elbows: elbow manufacturers stamping elbow welding precautions: national standard elbows to prevent eyeball erosion caused by heating stamping elbows, the welding current should not be too large, less than about 20% of carbon steel electrodes, and the arc is not suitable When it is too large or too long, the interlayer cooling rate is fast, and the welding path is narrow. After welding, the weld hardenability of the bent pipe is relatively high, and cracks are easy to occur. If the same type of stamping elbow is used for welding, preheating above 300°C and slow cooling at around 700°C are required after welding. If the welded parts cannot be heat treated. Stamping elbow electrodes should be used.
